Switch Machine Accessories

The PL-12 Adaptor Base should be used in association with most non-PECO turnouts, where the over-centre spring feature is not available. It can be affixed above or below the baseboard, and give the modeller the ability to "lock" the point blade...

For use with all solenoid motors (e.g. PL-10 and Pl-11). Connect this unit to the 16v ac supply on your transformer. The capacitor stores up power and discharges a 'kick' to ensure turnout blades 'snap over' every time. See the "Manufacturer" page for...

Push on Terminal Connectors and shrouds. These connectors make modification and fault finding so much easier than soldered wiring. Use them to connect the PL-38 Wire to PL-26 Passing Contact Switches, PL-22 On/Off Switches, PL-23 On/On Switches, and...

Manufactured by NJ International. For switch machine #6000. Only the quantity shown in stock is currently available.

See the "Manufacturer" page for general delivery and pricing information.

To mount the "Tortoise" switch machine above or below benchwork. See the "Manufacturer" page for general delivery and pricing information.

Pack of five plates, with fixing screws, for PL-10 series turnout motors. See the "Manufacturer" page for general delivery and pricing information.

Houses 6 PL-26 Passing Contact Switches, PL-22 On/Off Switches or PL-23 On/On Switches. See the "Manufacturer" page for general delivery and pricing information.

Simple, inexpensive switch easily fitted underneath the Turnout Motor (PL-10) to provide electrical switching for frog polarity, signals etc. Suitable only for HO and larger scales. Rated 1.5A. See the "Manufacturer" page for general delivery...

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors. The PL-31 Connectors are ideal for attaching the PL-34 Wiring Looms or PL-38 wire to these switches without soldering; the included Shrouds prevent...

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors. The PL-31 Connectors are ideal for attaching the PL-34 Wiring Looms or PL-38 wire to these switches without soldering; the included Shrouds prevent...

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors. The PL-31 Connectors are ideal for attaching the PL-34 Wiring Looms or PL-38 wire to these switches without soldering; the included Shrouds prevent...

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors. The PL-31 Connectors are ideal for attaching the PL-34 Wiring Looms or PL-38 wire to these switches without soldering; the included Shrouds prevent...

Manufactured by NJ International. For switch machine #6000. Only the quantity shown in stock is currently available.

Makes wiring the PL-10 series of Motors quick and easy. Just a simple push fit onto the motor terminals; the other ends are tinned and ready for the PL-39 Terminal Block, PL-50 Switch Module Unit, or PL-31 Push on Terminal Connectors. See the...