Electrical Accessories (DCC)
-
Automatic polarity reverser "Dual Frog Juicer", 2 frogs
Tam Valley Depot
$49.95For all DCC systems including NCE PowerCab. This board can be configured to use as an automatic polarity reverser for two frogs, a reversing loop, a turntable, a wye, or a crossing. It uses the same basic design as the hex frog juicer but has...- SKU:
- TAM-DFJ003U
- Availability:
- Available. Current stock: 5
- Scale:
- All Scales
$49.95 -
Automatic polarity reverser "Hex Frog Juicer", 6 frogs
Tam Valley Depot
$112.50For 2A to 8A DCC systems, including NCE PowerCab. This board can be configured to use as an automatic polarity reverser for six frogs, or a reverser for one to three reversing loops, turntables, wyes, or crossings. Setup is simple; connect...- SKU:
- TAM-HFJ003U
- Availability:
- Available. Current stock: 12
- Scale:
- All Scales
$112.50 -
Automatic polarity reverser "Mono Frog Juicer", 1 frog
Tam Valley Depot
$20.75For all DCC systems including NCE PowerCab. This board is an automatic polarity reverser for a single frog. Setup is simple, connect two wires to the DCC bus and one wire to a frog. The frog should be fully isolated. When a train...- SKU:
- TAM-MFJ003U
- Availability:
- Available. Current stock: 6
- Scale:
- All Scales
$20.75 -
Automatic program track "Auto-Sw", for "PowerCab"
NCE Corp.
$36.95Adds a separate program track to Power Cab system. Prevents accidental programming of ALL locos on your track when using Program Track mode. Automatically disconnects your main line when in Program Track mode but does not affect Program on Main...- SKU:
- 524-226
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$36.95 -
Automatic reverse "AR-2", w/adjustable delay
Circuitron
$72.50Same as AR-1, but with adjustable delay to hold train at sensor before reversing. Adjustable delay from one second to over one minute. Can be connected to pushbutton or DT-4 to permit stops and delays without reversing. Requires 12-18 Vdc power supply...- SKU:
- 800-5401
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$72.50 -
Automatic reverser "AR10", with circuit breaker
NCE Corp.
$77.95The AR10 is an automatic reverse loop controller for DCC layouts. It requires just 4 connections, two to the main line and two to the loop. In addition it functions as a circuit breaker for the reverse loop. Recommended for DCC systems from 1A to 10A...- SKU:
- 524-233
- Availability:
- Available. Current stock: 2
- Scale:
- All Scales
$77.95 -
Battery pack "BP600MH", 600mAh, 3.6V
Digitrax, Inc.
$14.95Nickel-Metal Hydride 600mAh 3.6V rechargeable battery pack. Compatible with Digitrax throttles with 3-pin battery plug. Chargeable when inside Digitrax throttles, no need to remove the battery cover. No battery “memory” effect. Works with...- SKU:
- 245-BP600MH
- Availability:
- Available. Current stock: 4
- Scale:
- All Scales
$14.95 -
Connector, edge (x3)
Digitrax, Inc.
$13.95For use with PM4 series boards, BDL16 series boards and SE8 series boards. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-CARDEDGE
- Availability:
- Available. Current stock: 4
- Scale:
- All Scales
$13.95 -
Controller, auto reversing, one reversing district
Digitrax, Inc.
$37.95Features: Cost effective automatic reversing for one reversing section or subdistrict User selectable trip current lets you adjust the AR1 to work with any scale or equipment on your layout Auto-Reversing manages polarity mismatches on the reversing...- SKU:
- 245-AR1
- Availability:
- Available. Current stock: 4
- Scale:
- All Scales
$37.95 -
Diodes, remote sensing, 2 sections
Digitrax, Inc.
$13.85Eliminates the need for long runs of heavy gauge wire between the BDL168 & remotely located track sections. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-RD2
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$13.85 -
Harness, 4-pin, 6 pairs
NCE Corp.
$14.95See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 524-309
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$14.95 -
Modular adaptor (RJ12) (x3)
Digitrax, Inc.
$13.95Use for joining "LocoNet" cables, adding coiled cords to throttles, etc. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-LNMC3
- Availability:
- Available. Current stock: 3
- Scale:
- All Scales
$13.95 -
Noise suppressor "Snubber", track bus (x2)
NCE Corp.
$17.75The NCE "Snubber" DCC track bus noise suppressor reduces or eliminates voltage spikes on long runs of DCC bus wire. This is especially important on any DCC track bus wire 40 feet or longer. It protects decoders from damaging inductive voltage...- SKU:
- 524-305
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$17.75 -
Occupancy detector, "LocoNet", 16 sections
Digitrax, Inc.
$174.95The BDL168 is a cost effective LocoNet Occupancy Detector for 16 detection sections. It lets you know when detection sections of your layout are occupied. When used in conjunction with one or two RX4 transponder detectors it operates up to 8 transponding...- SKU:
- 245-BDL168
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$174.95 -
Occupancy detector, "LocoNet", 4 sections
Digitrax, Inc.
$42.75Features: Low-cost, High-sensitivity DCC block-occupancy detection. Adjustable resistance/current detection section (DS) trip threshold. 8A capacity, suitable for all scales and track wiring configurations. Noise resistant and...- SKU:
- 245-BD4N
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$42.75 -
Occupancy detector, "LocoNet", 8 sections
Digitrax, Inc.
$204.95BXP88 makes adding detection and transponding to your layout easier than ever. No more complicated wiring! Features: DCC Occupancy Detection supports up to 8 detection sections letting you know when equipped rolling stock is in a detection...- SKU:
- 245-BXP88
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$204.95 -
Occupancy detector/auto reverser/power manager
Digitrax, Inc.
$56.50The BXPA1 is a combination DCC auto-reverser, occupancy detector, transponding detector and intelligent power manager. It is designed to make transponding implementation easy and provide advanced DCC track management by communicating all state...- SKU:
- 245-BXPA1
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$56.50 -
Plug, booster terminal, black
Digitrax, Inc.
$9.25Black replacement terminal plug for lost or damaged plugs on DB220 booster. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-BLKBOOSTPLU
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$9.25 -
Plug, booster terminal, grey
Digitrax, Inc.
$7.95Grey replacement terminal plug for lost or damaged plugs on Digitrax Command Stations and Boosters. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-BOOSTERTERMPLUG
- Availability:
- Available. Current stock: 6
- Scale:
- All Scales
$7.95 -
Plug, RJ12 (x20)
Digitrax, Inc.
$13.95Use with crimper tool to make custom length "LocoNet" cables and replace broken plugs. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-LNRJ12P20
- Availability:
- Available. Current stock: 5
- Scale:
- All Scales
$13.95