Decoder "LokPilot 5 micro DCC", control, 8-pin plug
- Usually in stock.
"The LokPilot 5 micro DCC is the "twin brother" of the LokPilot 5 DCC. With just 8.0mm x 7.0mm and a thickness of only 2.4mm (on the capacitor: 2.9mm), just so small that it can also be accommodated in very small locomotives of nominal sizes Z, N or TT, it is a pure DCC decoder. LokPilot 5 decoders are offered with all common interfaces.
The LokPilot 5 micro DCC is a "pure-bred" DCC decoder. 14 to 128 speed steps are as natural as 2- and 4-digit addresses. Up to 32 functions can be triggered. Thanks to RailComPlus® the decoders register automatically with a suitable DCC system like the ESU CabControl. The decoder accepts all DCC programming modes and thanks to RailCom® the CV values can be read on the main track with RailCom equipped DCC systems. For command stations that only program the CVs from 1-255 auxiliary CV registers exist. The LokPilot 5 micro DCC decoder recognizes the Märklin® braking sections as well as the ZIMO® HLU / ZACKCommands or the Lenz® ABC system. Also braking with DCC brake modules or with DC voltageis possible. It also stops with a Selectrix® brake diode. An ABC automatic shuttle trainenables automatic commuting between two train stations. The LokPilot 5 micro DCC decoder can be used on analog DC trains. The top speedcan be set separately. The decoder switches between the operating modes fully automatically "on-the-fly".
We know that you want your locomotives to be as realistic as possible. Therefore we have the LokPilot 5 micro DCC packed with function outputs. The variants with 6-pin or 8-pin wiring harnesses offer 4 amplified function outputs, each with 180mA output current and two logic level outputs. The versions with Next18 or PluX16 interface have a total of 6 amplified outputs and two logic level outputs available. All important lighting effects are available. The brightness of each output can be adjusted separately. The decoder masters automatic pushing and pulling when uncoupling for ROCO®, Krois® and Telex® couplings.
The engine control of the LokPilot 5 micro DCC has been fundamentally improved again. A variably adjustablePWM clock frequency from 10kHz to 50kHz ensures super quiet operation, especially with bell-armature motors. Operation - the typical “hum” is a thing of the past. The load control now has up to10 CVs which can be adjusted for difficult cases. The unique "Autotune" function enablesthe automatic calibration of the decoder to the motor. The LokPilot 5 micro DCC decoder delivers up to 1.5A of motor current. Enough juice even for older motors.
On request, a PowerPack can be fitted to the LokPilot 5 micro DCC to bridge dirty rail sections.
Protection. Of course, all function outputs and the motor output are protected against overload. We want you to enjoy your decoder for as long as possible."
See the "Manufacturer" page for general delivery and pricing information.