Digital Command Control (DCC)
-
DCC AccessoriesDCC Starter SetsDecoders
-
Motherboard "IB-MB1-NC", board replacement, InterMountain/Bowser
Train Control Systems
$67.95This motherboard is designed to replace the DCC decoder found in DCC equipped Intermountain and Bowser diesel locomotives. Created to fit the Intermountain ES44 as well as the Bowser S12, the IB-MB1 will fit a wide array of other locomotives. However,...- SKU:
- 745-1619
- Availability:
- Available. Current stock: 0
- Scale:
- HO
$67.95 -
Motherboard "IB-MB2", board replacement, InterMountain/Bowser
Train Control Systems
$67.95This motherboard is designed to replace the original lighting board in Intermountain and Bowser diesel locomotives. Created to fit the Intermountain SD40-2 as well as the Bowser C-636, the IB-MB2 will fit a wide array of other locomotives. However, it...- SKU:
- 745-1618
- Availability:
- Available. Current stock: 0
- Scale:
- HO
$67.95 -
Motherboard "IB-MB2-NC", board replacement, InterMountain/Bowser
Train Control Systems
$67.95This motherboard is designed to replace the DCC decoder in DCC-equipped Intermountain and Bowser diesel locomotives. Created to fit the Intermountain SD40-2 as well as the Bowser C-636, the IB-MB2-NC will fit a wide array of other locomotives. However,...- SKU:
- 745-1620
- Availability:
- Available. Current stock: 0
- Scale:
- HO
$67.95 -
Motherboard "RTR-MB1", board replacement, Athearn
Train Control Systems
$67.95This motherboard is designed to replace the original lighting board in the Athearn Diesel Ready-To-Roll locomotives. Included on this motherboard is a KA2 Keep Alive® for smooth operation over troublesome tracks. Pair with a WOW121 for...- SKU:
- 745-1615
- Availability:
- Available. Current stock: 0
- Scale:
- HO
$67.95 -
Mounting kit, terminal strip
Digitrax, Inc.
$19.50Each terminal strip board can handle from 1 to 4 signal heads. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-TSMK
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$19.50 -
Noise suppressor "Snubber", track bus (x2)
NCE Corp.
$17.75The NCE "Snubber" DCC track bus noise suppressor reduces or eliminates voltage spikes on long runs of DCC bus wire. This is especially important on any DCC track bus wire 40 feet or longer. It protects decoders from damaging inductive voltage...- SKU:
- 524-305
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$17.75 -
Occupancy detector, "LocoNet", 16 sections
Digitrax, Inc.
$174.95The BDL168 is a cost effective LocoNet Occupancy Detector for 16 detection sections. It lets you know when detection sections of your layout are occupied. When used in conjunction with one or two RX4 transponder detectors it operates up to 8 transponding...- SKU:
- 245-BDL168
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$174.95 -
Occupancy detector, "LocoNet", 4 sections
Digitrax, Inc.
$42.75Features: Low-cost, High-sensitivity DCC block-occupancy detection. Adjustable resistance/current detection section (DS) trip threshold. 8A capacity, suitable for all scales and track wiring configurations. Noise resistant and...- SKU:
- 245-BD4N
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$42.75 -
Occupancy detector, "LocoNet", 8 sections
Digitrax, Inc.
$204.95BXP88 makes adding detection and transponding to your layout easier than ever. No more complicated wiring! Features: DCC Occupancy Detection supports up to 8 detection sections letting you know when equipped rolling stock is in a detection...- SKU:
- 245-BXP88
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$204.95 -
Occupancy detector/auto reverser/power manager
Digitrax, Inc.
$56.50The BXPA1 is a combination DCC auto-reverser, occupancy detector, transponding detector and intelligent power manager. It is designed to make transponding implementation easy and provide advanced DCC track management by communicating all state...- SKU:
- 245-BXPA1
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$56.50 -
Panel "UTP"
NCE Corp.
$33.25Cab bus panel. All four RJ-12 jacks are wired in parallel for easy plug 'n play use. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 524-207
- Availability:
- Available. Current stock: 4
- Scale:
- All Scales
$33.25 -
Panel, interconnect, "LocoNet", universal.
Digitrax, Inc.
$21.95Features: Plug and Play Universal fascia panel supporting LocoNet. Two RJ12 front panel Throttle jacks. Three RJ12 rear pass-through LocoNet jacks Supports throttle charging. Fully connectorized installation. 2mm rear plug for e.g. PS14 DC power supply...- SKU:
- 245-UP7
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$21.95 -
Plug "21-HW-Male", European hardware, 21-pin (x5)
Train Control Systems
$34.50The 21-HW-Male is a circuit board with a 21-pin NEM660 (MTC21) connector and solder pads to connect wires. The male 21-pin socket may be used with any 21-pin decoder such as the WOW121 or EU621. The decoder can then be hardwired directly to your...- SKU:
- 745-1653
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$34.50 -
Plug, booster terminal, black
Digitrax, Inc.
$9.25Black replacement terminal plug for lost or damaged plugs on DB220 booster. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-BLKBOOSTPLU
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$9.25 -
Plug, booster terminal, grey
Digitrax, Inc.
$7.95Grey replacement terminal plug for lost or damaged plugs on Digitrax Command Stations and Boosters. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-BOOSTERTERMPLUG
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
$7.95 -
Plug, Digitrax 9 pin (x5)
Digitrax, Inc.
$25.50Replaces 9 pin plug-equipped decoder for DC operation of locomotive. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-DHDP
- Availability:
- Available. Current stock: 1
- Scale:
- HO
$25.50 -
Plug, Digitrax 9 pin (x5) (N)
Digitrax, Inc.
$25.50Replaces 9 pin plug-equipped decoder for DC operation of locomotive. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 245-DNDP
- Availability:
- Available. Current stock: 0
- Scale:
- N
$25.50 -
Plug, extension, 9-pin JST (x5)
Train Control Systems
$41.259-Pin JST female extension plug. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 745-1345
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
$41.25 -
Plug, extension, NMRA, 8 pin
Train Control Systems
$6.95An extension plug for the NMRA 8-pin connector. See the "Manufacturer" page for general delivery and pricing information.- SKU:
- 745-1253
- Availability:
- Available. Current stock: 7
- Scale:
- All Scales
$6.95 -
Plug, NMRA, 8 pin
Train Control Systems
$6.958 pin NMRA plug, pre-made and ready for wires to be soldered on from a decoder, etc. Can be plugged into any locomotive with an 8-pin connector. NOTE: This product does not include wires. See the "Manufacturer" page for general delivery and pricing...- SKU:
- 745-1254
- Availability:
- Available. Current stock: 7
- Scale:
- All Scales
$6.95
Subscribe to our newsletter
Get the latest modelling news, store specials, and new arrivals delivered to your inbox.