Description
Decoders without any interface can be contacted with individual terminals.
A quality coreless motor with flywheel serves in conjunction with LEDs indicating the direction for checking the motor output. Thus it is quite easy to check on the low speed performance and the even speed of the decoder. An LED monitor informs you about the functioning of the headlights and back-up lights as well as the function outputs AUX1 through AUX6.
For testing LokSound decoders we have integrated a 20 mm speaker. You may choose if the integral speaker should be switched off or if it should have 100 Ohm respectively 16 Ohm – thus the decoder tester is perfectly suitable for any ESU decoder generation!
Two SUSI plugs facilitate the direct test of optional SUSI modules as well as the connection to another circuit board.
The electrical connection to either the command station or the LokProgrammer is facilitated by a removable, 2-pole terminal block (same system as used on the LokProgrammer and the ECoS) or via two solder points.
See the "Manufacturer" page for general delivery and pricing information.
Related Products
Tester, decoder/"LocoNet" cable
Digitrax, Inc.
- SKU:
- 245-LT1
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
Decoder, signal.
Digitrax, Inc.
- SKU:
- 245-SE74
- Availability:
- Available. Current stock: 3
- Scale:
- All Scales
Decoder, stationary, 2 turnouts
Digitrax, Inc.
- SKU:
- 245-DS52
- Availability:
- Available. Current stock: 0
- Scale:
- All Scales
Wand, for use with "SoundCar" decoder
SoundTraxx
- SKU:
- 678-810141
- Availability:
- Available. Current stock: 1
- Scale:
- All Scales
Test kit, decoder
SoundTraxx
- SKU:
- 678-829001
- Availability:
- Sold out after current stock is depleted.
- Scale:
- All Scales